EH-102: Medium Speed Epoxy Hardener |
|
||||||||||||||||
Product DescriptionEH-102 is an aliphatic epoxy hardener that is compatible with both DR and ER series resin systems. Hardener has good resistance to amine blush and has excellent room temperature properties. Processing Mix resin and hardener thoroughly at specified ratio. Resin can be heated slightly to lower viscosity. Do not expose resin or hardener to excessive moisture conditions until fully cured. Post-cure resin to 160oF to achieve maximum cure and composite strength. In cases of free standing post-cures, the part should be heated slowly (20-30oF per 30 minute steps) to prevent warpage. |
Applications Moderately large marine and hand laminating projects which require 3-4 hours working time * Parts can be de-molded after 12 hours at 77oF without the typical epoxy brittle phase.
|
||||||||||||||||
Properties
Neat Resin Properties: Cured with ER-3, 24 hours @ RT, 2 hours @ 160oF
|
|||||||||||||||||
All data given is believed to be accurate based on the material tested. Since the processing and testing is application and user specific, API has no assurance of how the product will be used and therefore cannot make any guarantees as to these properties or the final performance. |
|||||||||||||||||
Address: Applied Poleramic Inc. Phone: (707) 747 6738 Fax: (707) 747 6774 Email: [email protected] 6166 Egret Court Benicia, CA 94510 Back to General Purpose Epoxies Back to Toughened Resin Systems |